Ubuntu PandaBoard Platform Configuration
|IMPORTANT NOTICE: The instructions given here are basically a more verbose version of the installation instructions found at the Ubuntu ARM and especially Ubuntu ARM/OMAP pages. In case of deviations, the instructions there should be given precedence because they are generally more up-to-date.|
|How to get started with Ubuntu using pre-built binaries on your OMAP Platform|
|Overview||Step 1||Step 2||Step 3||Step 4||Step 5||Step 6||Step 7||Step 8|
- Step 4
This page describes how your OMAP platform should be connected/setup
Hardware Platform Setup
The pictures depict the Blaze sEVM4430 (front and back)
and typical connections that will be used by most users.
The picture depicts Zoom-II OMAP34x MDP / Zoom OMAP36x MDP with the Debug board and typical connections that will be used by most users.
Connect device to the debug board using the J1 socket on the top of the debug board.
Note: The battery does not need be connected when the debug board is used.