PandaBoard Minimal-FS HW Configuration
|IMPORTANT: The content of this page is outdated. If you have checked or updated this page and found the content to be suitable, please remove this notice.|
EVEN MORE IMPORTANT: See Troubleshooting for up-to-date information and binaries. Information below is outdated.
|Setting up your Validation Environment on your OMAP Platform|
|Overview||Step 1||Step 2||Step 3||Step 4||Step 5||Step 6||Step 7||Step 8|
- Step 4
This page describes how your OMAP platform should be connected/setup
Hardware Platform Setup
The pictures depict the Blaze sEVM4430 (front and back)
and typical connections that will be used by most users.
The picture depicts Zoom-II OMAP34x MDP / Zoom OMAP36x MDP with the Debug board and typical connections that will be used by most users.
Connect device to the debug board using the J1 socket on the top of the debug board.
Note: The battery does not need be connected when the debug board is used.