PandaBoard Minimal-FS HW Configuration
|IMPORTANT: The content of this page is outdated. If you have checked or updated this page and found the content to be suitable, please remove this notice.|
EVEN MORE IMPORTANT: See Troubleshooting for up-to-date information and binaries. Information below is outdated.
|Setting up your Validation Environment on your OMAP Platform|
|Overview||Step 1||Step 2||Step 3||Step 4||Step 5||Step 6||Step 7||Step 8|
- Step 4
- Validation Environment
- Connect a USB thumb drive to the USB ports
- Connect your Serial cable or your USB2serial adapter
- Connect you display cable in either the HDMI or DVI connection port. You may need to adjust the bootargs if a DVI display is used.
- Make sure you have a open wireless connection to test WLAN
Note: Where USB2serial adapter is mentioned, it is actually meant to be plugged directly into the Pandaboard's serial port, not in a USB port of the Pandaboard. The USB side of the adapter goes into your computer.