From OMAPpedia

Revision as of 18:10, 11 October 2010 (edit) Orbarron (Talk | contribs) m (moved Minimal-FS Configuration to PandaBoard Minimal-FS HW Configuration) ← Older edit		Latest revision as of 16:42, 9 April 2011 (edit) (undo) Omapwiki (Talk | contribs)
(2 intermediate revisions not shown)
Line 15:		Line 15:
	</p>		</p>
	:<big><b>Step 4</b></big>		:<big><b>Step 4</b></big>
		+
Line 20:		Line 21:
	{{PandaBoard Configuration}}		{{PandaBoard Configuration}}
		+
		+	;Validation Environment:
		+	# Connect a USB thumb drive to the USB ports
		+	#Connect your Serial cable or your USB2serial adapter
		+	# Connect you display cable in either the HDMI or DVI connection port. You may need to adjust the bootargs if a DVI display is used.
		+	# Make sure you have a open wireless connection to test WLAN
		+
		+	''Note:'' Where USB2serial adapter is mentioned, it is actually meant to be plugged directly into the Pandaboard's serial port, not in a USB port of the Pandaboard. The USB side of the adapter goes into your computer.
	<hr>		<hr>

---

Latest revision as of 16:42, 9 April 2011

IMPORTANT: The content of this page is outdated. If you have checked or updated this page and found the content to be suitable, please remove this notice.

EVEN MORE IMPORTANT: See Troubleshooting for up-to-date information and binaries. Information below is outdated.

	Setting up your Validation Environment on your OMAP Platform
	Overview	Step 1	Step 2	Step 3	Step 4	Step 5	Step 6	Step 7	Step 8

   

Step 4

[edit] Hardware Setup

[edit] PandaBoard Configuration

Connections steps Connect USB keyboard and USB mouse Connect ethernet cable Connect serial cable or USB2serial adapter Connect display cable to the HDMI connection port

Additional Guides OMAPvideo PandaBoard Display connection option

Validation Environment

1. Connect a USB thumb drive to the USB ports
2. Connect your Serial cable or your USB2serial adapter
3. Connect you display cable in either the HDMI or DVI connection port. You may need to adjust the bootargs if a DVI display is used.
4. Make sure you have a open wireless connection to test WLAN

Note: Where USB2serial adapter is mentioned, it is actually meant to be plugged directly into the Pandaboard's serial port, not in a USB port of the Pandaboard. The USB side of the adapter goes into your computer.

---

Previous	Home	Next