PandaBoard Minimal-FS HW Configuration
From OMAPpedia
(Difference between revisions)
m |
|||
| (4 intermediate revisions not shown) | |||
| Line 17: | Line 17: | ||
| - | |||
| + | =Hardware Setup= | ||
| + | {{PandaBoard Configuration}} | ||
| + | |||
| + | |||
| + | ;Validation Environment: | ||
| + | # Connect a USB thumb drive to the USB ports | ||
| + | #Connect your Serial cable or your USB2serial adapter | ||
| + | # Connect you display cable in either the HDMI or DVI connection port. You may need to adjust the bootargs if a DVI display is used. | ||
| + | # Make sure you have a open wireless connection to test WLAN | ||
| + | |||
| + | ''Note:'' Where USB2serial adapter is mentioned, it is actually meant to be plugged directly into the Pandaboard's serial port, not in a USB port of the Pandaboard. The USB side of the adapter goes into your computer. | ||
<hr> | <hr> | ||
Latest revision as of 16:42, 9 April 2011
 |
IMPORTANT: The content of this page is outdated. If you have checked or updated this page and found the content to be suitable, please remove this notice. |
EVEN MORE IMPORTANT: See Troubleshooting for up-to-date information and binaries. Information below is outdated.
 | Setting up your Validation Environment on your OMAP Platform | ||||||||
| Overview | Step 1 | Step 2 | Step 3 | Step 4 | Step 5 | Step 6 | Step 7 | Step 8 | |
- Step 4
[edit] Hardware Setup
[edit] PandaBoard Configuration
|
|
- Validation Environment
- Connect a USB thumb drive to the USB ports
- Connect your Serial cable or your USB2serial adapter
- Connect you display cable in either the HDMI or DVI connection port. You may need to adjust the bootargs if a DVI display is used.
- Make sure you have a open wireless connection to test WLAN
Note: Where USB2serial adapter is mentioned, it is actually meant to be plugged directly into the Pandaboard's serial port, not in a USB port of the Pandaboard. The USB side of the adapter goes into your computer.
| 
| 
|
| Previous | Home | Next |
