Android Target Device configuration
Configuring the Target Device
For instructions on how to setup the Zoom/Blaze hardware, refer to Platform Configuration
Connect the Target board to PC
To setup Blaze with Teraterm/Hyperterm, configure as below, and use COM 11 (3rd port out of the 4 ports discovered) to set up the terminal.
To setup Zoom2 to display debug messages via Teraterm/Hyperterm on a PC, connect and configure the below.
Connect a USB cable (mini-B connector) to the J12 receptacle and the other side to the USB port on PC. Windows PC should recognize the USB to serial device connection as "USB Serial Converter A".
For instructions on how to configure this, refer Platform to PC