From OMAPpedia

Revision as of 23:53, 17 June 2010 (edit) Ccd admin (Talk) (Created page with '__NOTOC__ =Configuring the Target Device (Zoom)= For instructions on how to setup the Zoom hardware, refer to [http://omappedia.com/wiki/Platform_Configuration Platform Configur…') ← Older edit

Revision as of 18:23, 16 July 2010 (edit) (undo) Omapwiki (Talk | contribs) m (1 revision: android related pages) Newer edit →

---

Revision as of 18:23, 16 July 2010

Configuring the Target Device (Zoom)

For instructions on how to setup the Zoom hardware, refer to Platform Configuration

Connect the Target board to PC

To setup Zoom2 to display debug messages via Teraterm/Hyperterm on a PC, connect and configure the below.

Connect a USB cable (mini-B connector) to the J12 receptacle and the other side to the USB port on PC. Windows PC should recognize the USB to serial device connection as "USB Serial Converter A".

For instructions on how to configure this, refer Platform to PC